1 Laboratory of Instrumentation, Imaging and Spectroscopy (L2IS), National Polytechnic Institute Félix Houphouët-Boigny, Department of Electrical and Electronic Engineering, Yamoussoukro BP 1093, Côte d’Ivoire.
2 Laboratory of Fundamental and Applied Physics (LPFA), Nangui Abrogoua University, Training and Research Unit in Fundamental and Applied Sciences, 02 BP 808 Abidjan 02, Côte d’Ivoire.
3 Laboratory of Fundamental Physical Sciences, École Normale Supérieure (ENS), Cocody, Abidjan, Department of Science and Technology, Physics-Chemistry Section, 08 BP 10 Abidjan 08, Côte d’Ivoire.
4 Training and Research Unit in Science and Technology, Department of Physics, University of Man, BP 20 Man, Côte d’Ivoire.
* Corresponding Author
ORCID Details
Serge Martial Adepo: https://orcid.org/0009-0007-0840-4666
Anicet Kouabenan Kouakou: https://orcid.org/0009-0004-6531-7161
Guy-Oscar Regnima: https://orcid.org/0009-0008-9832-1887
GSC Advanced Research and Reviews, 2026, 29(01), 412–424
Article DOI: 10.30574/gscarr.2026.29.1.0296
Received on 16 September 2026; revised on 26 October 2026; accepted on 28 October 2026
The accurate determination of absorption and scattering coefficients in highly diffusive media remains a challenging task due to the strong coupling between these two parameters. In this study, we propose an original inverse approach for estimating the absorption coefficient (μ_a) and the scattering coefficient (μ_s) from a single measurement of the extinction coefficient (μ_e) obtained using the Structured Laser Illumination Planar Imaging (SLIPI-1p) technique.
The method combines the Beer–Lambert law with the Kubelka–Munk model in order to formulate a nonlinear inverse problem. A multi-thickness transmittance reconstruction strategy is introduced to generate additional constraints from a single experimental measurement. The resulting system is solved using numerical optimization techniques, allowing the simultaneous estimation of μ_a and μ_s without imposing empirical assumptions on their ratio. The proposed approach estimates the absorption and scattering coefficients without prescribing an empirical fixed ratio between them, by fitting the Kubelka–Munk model to transmittance values reconstructed from the experimentally measured extinction coefficient.
The approach was applied to diluted milk solutions at a wavelength of 450 nm, representative of highly diffusive media. The obtained results reveal a strong dominance of scattering over absorption, in agreement with the known optical behavior of such media. The estimated values are in good agreement with the orders of magnitude reported in the literature, thereby confirming the validity of the proposed method.
Although the method relies on reconstructed transmittance data, it provides a simple and physically consistent framework for extracting optical properties from limited experimental measurements. This work highlights the potential of combining SLIPI-based measurements with inverse modeling techniques for the quantitative characterization of complex scattering media.
SLIPI-1p; Kubelka–Munk; Inverse Problem; Optical Properties; Scattering Media; Extinction Coefficient.
Preview Article PDF
Serge Martial Adepo, Anicet Kouabenan Kouakou, Guy-Oscar Regnima, Jocelyne Mamaket Bosson and Thouakesseh Jérémie Zoueu. INVERSE DETERMINATION OF ABSORPTION AND SCATTERING COEFFICIENTS IN HIGHLY DIFFUSIVE MEDIA USING SLIPI-1P AND KUBELKA–MUNK MODELING. GSC Advanced Research and Reviews, 2026, 29(01), 412–424. Article DOI: https://doi.org/10.30574/gscarr.2026.29.1.0296.